NR Class Loco Windscreen Wiper Systems

ARE YOU PREPARED TO RISK THE ALTERNATIVE ?

NR FRONT WINDSCREEN WIPER SYSTEMS

Double Arm Assembly

NRPHOTO

Above: NR 4 at Acacia Ridge, Queensland.

The Prime Double Arm Assembly consists of a single motor, mounted on a galvanised channel. The motor operates two Arms and Blades via Linkages contained within the channel.

We don’t just give you a box of parts, you receive the unit fully assembled so there is no guess work or fitting of linkages.

All that is required is drilling of holes, fitting the assembly and adding the Arms and Blades.

Features:

Modular design allows easy fitting without further assembly
Parks away from drivers line of vision
Above ground motor is ideal for diesel-electric applications
Cost effective
Maximum screen coverage
12 or 24 Volt available (24V standard)
2 assembly sizes available
No hand access to moving parts
Internal circuit breaker

Technical features per screen assembly

Available voltage DC:12 - 24

Starting torque 30 Nm

Cycles per minute(Nominal) 40 on low, 55 on high (no load)

Operating current draw(no load) 0.4 amps on low,0.7 amps on high @27VDC(no load)

Maximum current draw (using 2 x 450mm arms & 2 x 500mm blades on dry screen) 3.7 amps

Stall current draw 9.3 amps on low,11.0 amps on high @27 VDC

Pivot shaft centres 785mm or 890mm

Self parking Right or left

Previous installations:

120 x NR Locos-United Group Rail

12 x 81 Class rebuilds-United Group Bendigo

30 x 422 Class rebuilds-EDI Rail SA

12 x 5000 Class Locos

10 x RL locos NREC ALCO

Numerous other single installations

NRFRONTSYS

Washer systems also available:

Available voltage DC:12 - 24

Maximum current draw 3.0 Amps @ 27VDC

Maximum head 3 Metres

Capacity 2 & 4 L (1 pump)5.8L (1 pump) 10L (1,2 or 3 pumps)

NRWASHER

Water is supplied to the washer nozzles which are attached to the end of the wiper arms.

NR REAR WINDSCREEN WIPER SYSTEMS

Single arm assembly (Radial or pantograph)

nrrearphoto

The Prime single arm assembly consists of a single motor mounted on a small channel. The motor operates one arm and blade via a linkage contained within the channel.

We don’t just give you a box of parts, you receive the unit fully assembled so there is no guess work or fitting of linkages.

All that is required is drilling of holes, fitting the assembly and adding the arm and blade.

Features: